AAD Dodge Charger Challenger 300 Magnum Billet Front Upper Control Arms | Worldwide delivery

DESCRIPTION

Full billet aluminum, fully-adjustable Front Upper Control Arms for your 2WD Charger, Challenger, Magnum, 300, Hellcat, etc. These Arms use our unique tab-lock system to facilitate easy, on-vehicle Camber adjustment so that when you lower your ride, you can get your Front Camber back in spec.

Patent Pending Spheriflex bearing, a teflon impregnated Delrin spherical bearing, to reduce or eliminate the slop in the OEM parts.

Machined from 6061-T6511 billet aluminum and 17-4 Stainless steel. Tabs are laser-cut for exact fit, and all hardware is high-strength with OEM-quality plating to resist corrosion.  

Weigh approximately 1 pound less than the OEM parts (each) but are significantly stronger in all directions.

We use a high-end, FK stainless-steel, Teflon-lined spherical bearing for the joint that is angled 5-degrees to prevent joint bind at full droop. This bearing is replaceable and will last for years without issue.

INSTALLATION

Here is our Installation Instructions for these part!

WARRANTY

Here is our 1 Year Limited Warranty Information.