Hawk 2010 HP+ Street Rear Brake Pads | Worldwide delivery

• Low to mid temperature range
• Fade resistant
• Smooth & predictable torque
• Ideal for Autocross
• All Hawk Performance compounds are not compatible with carbon ceramic rotors. Hawk pads are designed to work with Iron/Metal rotors.
• Street

Hawk Brake Pad Installation Procedure

• Install Brake pads properly. Be sure pads are securely positioned in the caliper.
• Flush system with fresh brake fluid.
• Check all hydraulic parts for excess wear and tear.
• Check disc for proper thickness, parallelism, and lateral run-out.
• Check disc for scoring or grooves over .012'' depth. If either applies, resurfacing or replacement is required.
• If disc does not need resurfacing then contamination from the previous brake pads must be removed. Sand discs with Garnet sandpaper using moderate pressure. Use soap and water to clean off disc surface after sanding and machining. Discs should be free and clear of oil, grease, and brake fluid
• Inspect calipers for freedom of movement. Lubricate where necessary

Hawk Brake Pad Bedding Procedure - Street Compounds

• Make 6-10 slow-downs from approximately 30-35 mph to 5 mph. applying moderate pressure. Do not come to a complete stop.
• Make an additional 2 to 3 harder stops from approximately 40-45 mph. to zero.
• DO NOT DRAG THE BRAKES! (after stopping - do not leave your foot on the brake pedal)
• Allow 15 minutes or more for the brake system to cool down.
• Your new Hawk pads are ready for use.

This Part Fits: